免费发布

【在邦】厂家二硫化钨润滑喷剂CSHPON 耐磨耐润滑脱模剂

更新:2022-10-27 08:46 发布者IP:114.95.47.183 浏览:0次
发布企业
上海在邦化工有限公司商铺
认证
资质核验:
已通过营业执照认证
入驻顺企:
9
主体名称:
上海在邦化工有限公司
报价
人民币¥100.00元每瓶
品牌
在邦
型号
CS-208
产地
上海
关键词
【在邦】厂家二硫化钨润滑喷剂CSHPON 耐磨耐润滑脱模剂
所在地
上海市嘉定区马陆丰饶路818号
联系电话
021-61521200
手机
13301614019
经理
高小姐  请说明来自顺企网,优惠更多
让卖家联系我
13301614019

产品详细介绍

“CSHPON二硫化钨润滑喷剂使用说明书

"CSHPON" Tungsten DisulfideLubricant Spray ProductSpecification

二硫化钨润滑喷雾剂是由二硫化钨粉末、高粘溶胶、分散剂、乳化剂,通过高压气雾混合灌装生产。其有良好的成膜性、附着力强、润滑性和耐磨性、抗极压性和耐高温。

Tungsten disulfide lubricant sprayconsists of tungsten disulfide power, highly viscous sol,dispersants, emulsifiers and propellants that are processed underhigh pressure and aerosol to form the final lubricant spray. Theproduct has excellent ability in film-forming property, layeradhesion, lubrication and resistance in wear, extreme pressure andhigh temperature.

 

产品特点 Key Feature

1.适用于开放环境场合,具有良好的快干性、润滑性、抗极压、耐磨性和高附着力。

1. Theproduct has the advantage in quick self-drying, lubricating,pressure and wear resistant and high adhesion.

2.耐温区间zui佳工作耐温-100℃—400℃,间歇耐温450℃。

2.Temperature range: optimum working temperature ranges between-100 ℃ to 400 ℃ withintermittent temperature at450 ℃.

3.耐腐蚀性:对大多数化学药品和溶剂,表现出惰性、能耐强酸强碱、水和各种有机溶剂。

3.Corrosion resistance:For most of the chemicals andsolvents, the product shows its inertia and resistance to acid,alkali, water and various organic solvents.

4.高润滑性:罐液吸附在工件表面,形成一个保护膜与膜紧密,摩擦系数小,起到很好的保护润滑。

4.Highlubrication: fluidabsorbed at the can surface forms a protective layer that is closedattached to the film. Friction coefficient is small in suchcondition, resulting in good protection and lubrication.

5.技术成熟,质量稳定,便于携带,使用方便。

5.The productis cost effective and easy to transport/use with mature technologyand stable

 

使用方法 Instruction

1.使用前,用力摇晃喷罐约80秒,以使罐液均匀,便于喷涂。

1. Beforethe usage, shake the spray cansvigorously for about 80 secondsto achieve uniform fluid inside the can which facilitate thefurther spraying.

2.请将需要润滑部位的油污和灰尘清洗干净。

2. Pleaseclean the lubricant area to prevent dust, oil stains.

3.保持喷口距离工件约30cm,来回移动,不要固定在一个位置,表面干燥约需30分钟。

3. Keepthe spout30cm awayfrom the workpiece. Do not fix the spout in one position and shouldmove back and forth. 30 minutes are needed to dry thesurface.

4.喷剂使用后长时间不用时,必须倒转罐身喷出几下,清洗喷嘴,以防止喷嘴堵塞。

If not usingfor a longtime, the spray can mustbe reversed and ejected for a few sprays. Cleaning nozzles shouldbe conducted to prevent clogging.

5.详细阅读产品使用说明书,并在工作人员指导使用。

5. Users shouldcarefully read the product manual and use under guidance of theprofessionals.

 

注意事项 Precautions

1.本品不含氟利昂。严禁烟火,注意室内通风。

1. Theproduct does not contain Freon. It is strictly prohibited tofireworks. Please ensure there is adequate indoorventilation.

2.存储在40℃环境下,直立罐体,空罐勿抛入火中。

2. Pleasestore under 40︒C (Celsius degree) and in upright position. Do notthrow empty cans into the fire.

3.不要使罐内液体接触眼睛,如果不小心溅入眼睛,请立即用流动清水或生理盐水冲洗。

3. Pleaseprevent the direct contact between the liquid and eyes. Ifaccidently splashed into eyes, rinse with flowing fresh water orsaline immediately. 

4.如果罐液不慎入口,应及时到医院急诊并采取相应的处理措施。

If theliquid accidently enters into mouth, please immediately approach tohospital for medical treatment.

5.禁止放置于在儿童可触及的地方,以免发生意外。

5. Pleasedo not store within the reach of children to preventaccidents. 

6.严禁在阳光下曝晒或存放在车里暴晒。

It isrestricted to store under direct sunlight or in vehicles underdirect sunlight. 

7.禁止敲击投掷罐体,运输过程中应小心轻放。

It isrestricted to ban or throw product cans. Transport should behandled with great care.

包装贮存  Packing andStorage
1.包装:500ml/罐,12罐/件,24罐/件。

1. Packing: 500 ml/can, 12cans/suite, 24 cans/suite
2.贮存:贮存于阴凉、干燥通风处。

2.Storage: please stored in a cooland dry ventilated place.


所属分类:中国精细化学品网 / 防锈润滑剂
【在邦】厂家二硫化钨润滑喷剂CSHPON 耐磨耐润滑脱模剂的文档下载: PDF DOC TXT
关于上海在邦化工有限公司商铺首页 | 更多产品 | 联系方式 | 黄页介绍
顺企网 | 公司 | 黄页 | 产品 | 采购 | 资讯 | 免费注册 轻松建站
免责声明:本站信息由企业自行发布,本站完全免费,交易请核实资质,谨防诈骗,如有侵权请联系我们   法律声明  联系顺企网
© 11467.com 顺企网 版权所有
ICP备案: 粤B2-20160116 / 粤ICP备12079258号 / 粤公网安备 44030702000007号 / 互联网药品信息许可证:(粤)—经营性—2023—0112