1、油墨特性:低气味,高光泽,色泽鲜艳,遮盖力强,耐酒精。
2、适用材料:主要应用于各种加硬强化片材,五金,电镀、也可用于PP材料。
3、技术参数:
a. 粘度:8000—12000CPS;
b. 细度:5UM↓ 、光泽:60°↑ ;
c. 干燥条件:65℃—80℃,30min
d. 铅笔硬度:2H↑ ;
e. 耐盐务性:24H;
f. 耐酒精:99%乙醇500g力来回50次;
g. 耐磨:500g力来回超过30次;
h. 过网性:77T—145T网纱〔金、银粉调配颜色除外〕
4、稀释剂的选择:稀释剂:S—3:便用前添加10%—15%的DB—01固化剂。
5、注意事项:
a. 使用前将油墨与固化剂搅拌均匀,用后随时封闭;
b、根据需要可添加15%—20%的稀释剂进行稀释;
c、施工件在施工前清除表面油渍及污物;
d、需多色套印时应等前面的颜色表干后进行套色;
e、在作测试时应先让墨层完全干燥;
f、不得将油墨与其它油墨混合及配色,添加固化剂后,效果会大大的改善,若加固化剂后请将油墨在4小时用完。
6、应急处理措施:
a、如浸溅到眼部立即清水清洗,严重者就医。
b、灭火急救措施:用干粉,泡沫灭火器或沙子灭火。
※备注:由于材料及使用中的变数,可能是结果会有变化,以上数据仅供参考,使用前请自行测试。
1. Ink characteristics: low odor, high gloss, bright color,strong covering power and alcohol resistance.
2, applicable materials: mainly used in various hardenedreinforced sheets, hardware, electroplating, and also for PPmaterials.
3. Technical parameters:
A. viscosity: 8000 - 12000CPS;
B. fineness: 5UM, gloss: 60 degrees;
C. drying conditions: 65 - 80 centigrade, 30min
D. pencil hardness: 2H;
E. resistance to salt: 24H;
F. alcohol resistance: 99% ethanol 500g force back and forth 50times;
G. wear-resistant: 500g force back and forth more than 30times;
H. over net: 77T 145T gauze [gold and silver powder except forcolor]
4. Diluent selection: diluent: S - 3: add 10% - 15% DB - 01curing agent before use.
5. Note:
A. mix ink and curing agent evenly before use and seal at anytime after use.
B, if necessary, add 15% - 20% diluent to dilute.
C, construction parts to remove surface oil stains and dirtbefore construction.
D, when multicolor overprinting is required, wait for the colortable to dry.
E, the ink layer should be completely dry in the test.
F, no ink and other ink mixing and matching. After adding curingagent, the effect will be greatly improved. If the curing agent isadded, please use the ink in 4 hours.
6. Emergency treatment measures:
A, if soaked to the eye, immediately rinse with water.
B, fire fighting first aid measures: dry powder, foam fireextinguisher or sand fire extinguishing.
Remarks: due to variations in material and usage, the resultsmay vary. The above data are for reference only. Please testyourself before using them.