中国西门子CPU一级代理商|模块代理

中国西门子CPU一级代理商|模块代理

中国西门子CPU一级代理商|模块代理

SINAMICS SD memory card

The parameter assignment, firmware and licenses for a converter canbe stored on the SINAMICS SD memory card. When service is required,e.g. after the converter has been replaced and the data have beendownloaded from the memory card the drive system is immediatelyready for use again.

The memory card has the following functions:

Parameter settings can be written from the memory card to theconverter or saved from the converter to the memory card

The memory card supports series commissioning without the use of acommissioning tool

If firmware is stored on the memory card, the firmware can beupgraded/downgraded during startup

It is used for storing licenses when using functions under license,e.g. the license for enabling the Extended Safety functions

Safe Stop 1 (SS1) 1)

Safe Stop 2 (SS2)

Safe Operating Stop (SOS)

Safely-Limited Speed (SLS)

Safe Speed Monitor (SSM)

Safe Direction (SDI)

Safely-Limited Acceleration (SLA)

Safe Brake Test (SBT) diagnostic function

Notes:

In general, the converter can be operated without a memory card.However, it is necessary if licenses, such as the Extended Safetylicense, are required. The card must then remain permanentlyinserted.

Firmware V5.2 or higher is required for the 3 AC series or whenusing the SINAMICS Startdrive commissioning tool.

1) Safe Stop 1 time controlled (SS1-t) can also be found inthe Basic Safety Functions.