EX600B13传感器带来愉悦使用
UHT-12™, high temperature, charge mode accelerometer kitcontaining a side exit accelerometer with shear sensing crystal, 10ft integral hard-line cable, and integral charge amplifier
High temperature, charge modeaccelerometer kit containing a side exit accelerometer, 10 ftintegral hard-line cable, and integral charge amplifier.
Sensitivity: (±5%) 100.0 mV/g (10.2 mV/(m/s²))
Sensing Element: UHT-12™
Measurement Range: ±50 g (±490 m/s²)
Weight: 10.5 oz (300 gm)
| English: | SI: | ||
|---|---|---|---|
| Performance | |||
| Sensitivity (±5 %) | 100.0 mV/g | 10.2 mV/(m/s²) | [1] |
| Measurement Range (Peak) | ±50 g | ±490 m/s² | |
| Frequency Range (±5 %) | 282 to 210000 cpm | 4.7 to 3500 Hz | [2][4] |
| Frequency Range (±10 %) | 204 to 300000 cpm | 3.4 to 5000 Hz | |
| Resonant Frequency | 1200 kcpm | 20 kHz | [5] |
| Broadband Resolution (1 to 10000 Hz) | 450 µg | 4415 µm/sec2 | [1][5] |
| Non-Linearity | ±1 % | ±1 % | [3] |
| Transverse Sensitivity | <5 % | <5 % | |
| Environmental | |||
| Overload Limit (Shock) | 1000 g pk | 9810 m/s² pk | [1] |
| Temperature Range (Accelerometer) | -65 to +900 °F | -54 to +482 °C | |
| Temperature Range (Charge Amplifier) | -60 to +250 °F | -51 to +121 °C | |
| Temperature Response | See Graph %/°F | See Graph %/°F | [5] |
| Base Strain Sensitivity | ≤0.006 g/µε | ≤0.06 (m/s²)/µε | [1] |
| Electrical | |||
| Settling Time (at 70 °F within 1% ofbias) | ≤1.0 sec | ≤1.0 sec | |
| Discharge Time Constant | ≥.10 sec | ≥.10 sec | |
| Excitation Voltage | 22 to 28 VDC | 22 to 28 VDC | |
| Constant Current Excitation | 2.2 to 20 mA | 2.2 to 20 mA | |
| Output Impedance | 1000 Ohm | 1000 Ohm | [5] |
| Output Bias Voltage | 12 to 16 VDC | 12 to 16 VDC | |
| Spectral Noise (10 Hz) | 30 µg/√Hz | 294 (µm/sec2)/√Hz | [1][5] |
| Spectral Noise (100 Hz) | 8 µg/√Hz | 78 (µm/sec2)/√Hz | [1][5] |
| Spectral Noise (1 kHz) | 4 µg/√Hz | 39 (µm/sec2)/√Hz | [1][5] |
| Electrical Isolation | 100000000 Ohm | 100000000 Ohm | |
| Physical | |||
| Size - Diameter | 1.5 in | 38.1 mm | |
| Size - Height | 0.75 in | 19.1 mm | |
| Weight (with cable) | 10.5 oz | 300 gm | |
| Mounting | Through Holes (3) | Through Holes (3) | |
| Sensing Element | UHT-12™ | UHT-12™ | |
| Sensing Geometry | Shear | Shear | |
| Housing Material | Inconel | Inconel | |
| Sealing | Welded Hermetic | Welded Hermetic | |
| Electrical Connector | 2-Pin MIL-C-5015 | 2-Pin MIL-C-5015 | |
| Electrical Connection Position | Side | Side | |
| Cable Length | 10 ft | 3 m | |
| Cable Type | Integral Hardline Cable | Integral Hardline Cable | |
All specifications are at room temperature unless otherwisespecified.
ProductNotes
[1] Conversion Factor 1g = 9.81 m/s².
[2] 1Hz = 60 cpm (cycles per minute).
[3] Zero-based, least-squares, straight line method.
[4] The high frequency tolerance is accurate within ±10% of thespecified frequency.
[5] Typical value.
[6] See PCB Declaration of Conformance PS116 for details.
Accessories:
| Supplied | |||
| 081A99 | Cap Screw | (3) | |
| ICS-1 | NIST-traceable single-axisamplitude response calibration from 600 cpm (10 Hz) to upper 5%frequency | (1) | |
OptionalVersions:
No optional versions
EX600B13传感器优惠接触